Men's
Tiger's Blood
Tiger's Blood
Jacket Sizing Information
There are three variables to consider when sizing an ICON jacket. The first two are the chest and sleeve measurements, which are what your jacket size is based on. The third is the the jacket fit type, which defines the “cut” of the jacket (Attack, Sport, or Relaxed). Instructions, sizing charts and jacket fit details can be found below. The fit type of every Icon jacket can be found in the first bullet point of the copy block for that individual product.
- Attack
- Sport
- Relaxed
Chest measurement instructions
While standing with your arms relaxed at your side, wrap a flexible tape measure around your chest at its largest point. The tape measure should go through your armpit and stay parallel with the floor while taking the measurement.
Sleeve measurement instructions
While standing with your arms relaxed at your side, place one end of a flexible tape measure on your spine at the base of your neck. Measure over the top of your shoulder, down over the point of your elbow, and finish at the wrist bone.
Mens Jacket Sizing Chart
- Size
- XS
- S
- M
- L
- XL
- 2XL
- 3XL
- 4XL
- 5XL
Mens Jacket Conversion Chart
Care Instructions
General Care
ICON®
jackets are tough and designed to withstand a great deal of asphalt
induced abuse, but no jacket can survive every conceivable motorcycle
accident. Should the unfortunate occur and you crash in your Icon jacket
thoroughly review the product for any signs of structural damage (major
abrasion, holes, damaged seams, etc). Should there be any damage or if
you are unsure if the damage is structural you should replace the
jacket. Most Icon textile jackets use a coating on the shell material
which reinforces the overall fabric matrix. Improper cleaning of the
jacket could compromise the integrity of this coating leading to
material failure. Unnecessary exposure to Sunlight and UV rays should be
avoided. This is most critical when storing your jacket. Always store
your jacket in a dark, well ventilated area. Jackets are best hung on a
wide padded hanger. Do not wrap in plastic or other nonporous materials
as this may cause the fabric to discolor. Finally, avoid exposing your
jacket (or any of your riding gear) to fumes or vapors from gasoline or
any harsh chemicals. These fumes weaken the structure of nylon and
polyester textiles lessening their inherent protective capabilities.
Pre-Cleaning
It
is important to follow a few simple steps to prepare your jacket for
washing. Remove the insulated liner from the jacket (if so equipped).
When removing the liner unsnap each snap carefully - DO NOT apply
excessive force - as this may break the snap. Remove all impact
protectors from the jacket. Make sure to close and fasten all the pocket
flaps.
Cleaning
Insulated
Liner - Hand wash the insulated liner in warm water with a mild liquid
laundry detergent. Thoroughly rinse insulated liner with clean water to
remove all detergent. Should you desire to clean the impact protectors
they can be cleaned by wiping the protectors with a damp cloth.
Jacket
(Textile Areas) - Hand wash the jacket with warm water and a mild
liquid laundry detergent. Hand washing minimizes unnecessary stress on
the garment. A soft bristle toothbrush works well in helping to remove
any bug strikes or road debris. Rinse the jacket with clean water to
remove all detergent. DO NOT use any form of oxygenated detergent,
bleach, fabric softeners, or dry cleaning
chemicals. These items will damage the jacket!
Drying
Insulated
Liner - The insulated liner should be allowed to drip dry-only. DO NOT
use a machine dryer, direct sunlight, hair dryers or any type of heater
during the drying process.
Jacket - DO NOT use a machine dryer.
Subjecting the jacket to a machine dryer will damage the jacket and
possibly the dryer itself. The only recommended method for drying the
jacket is drip-drying. Do not subject the jacket to direct sunlight,
hair dryers or any type of heater during the drying process. DO NOT use
an iron on any part of the garment.