Pants // Women's
Hella2
Hella2
Pant sizing information
There are three variables to consider when sizing ICON pants. The first two are the waist and inseam measurements, which are what your pant size is based on. The third is the fit type of the pant. Measurement instructions and sizing charts can be found below. The fit type of every ICON pant can be found in the first bullet point of the copy block for that individual product.
Waist measurement information
While standing in a relaxed position, measure around your natural waistline, while keeping the tape measure parallel to the floor.
Inseam measurement information
While standing in a relaxed position, measure the total length of the inside of your leg, from crotch to ankle.
Womens Pant Sizing Chart
- Waist Inches
- 23
- 25
- 27
- 29
- 31
- 33
- 35
- 37
Womens Pant Conversion Chart
Care Instructions
General Care
ICON®
pants are tough and designed to withstand a great deal of asphalt
induced abuse, but no pant can survive every conceivable motorcycle
accident. Should the unfortunate occur and you crash in your ICON® pant,
thoroughly review the product for any signs of structural damage (major
abrasion, holes, damaged seams, etc). Should there be any damage or if
you are unsure if the damage is structural, you should replace the pant.
Most Icon textile pants use a coating on the shell material which
reinforces the overall fabric matrix. Improper cleaning of the pant
could compromise the integrity of this coating leading to material
failure. Unnecessary exposure to Sunlight and UV rays should be avoided.
This is most critical when storing your pant. Always store your pant in
a dark, well ventilated area. Pants are best hung on a wide padded
hanger. Do not wrap in plastic or other nonporous materials as this may
cause the fabric to discolor. Finally, avoid exposing your pant (or any
of your riding gear) to fumes or vapors from gasoline or any harsh
chemicals. These fumes weaken the structure of nylon and polyester
textiles lessening their inherent protective capabilities.
Pre-Cleaning
It
is important to follow a few simple steps to prepare your pant for
washing. Remove the insulated liner from the pant (if so equipped). When
removing the liner unsnap each snap carefully - DO NOT apply excessive
force - as this may break the snap. Remove all impact protectors from
the pant. Make sure to close and fasten all the pocket flaps.
Cleaning
Insulated
Liner - Hand wash the insulated liner in warm water with a mild liquid
laundry detergent. Thoroughly rinse insulated liner with clean water to
remove all detergent. Should you desire to clean the impact protectors
they can be cleaned by wiping the protectors with a damp cloth.
Pant
- Textile Areas - Hand wash the pant with warm water and a mild liquid
laundry detergent. Hand washing minimizes unnecessary stress on the
garment. A soft bristle tooth brush works well in helping to remove any
bug strikes or road debris. Rinse the pant with clean water to remove
all detergent. DO NOT use any form of oxygenated detergent, bleach,
fabric softeners, or dry cleaning chemicals. These items will damage the
pant!
Drying
Insulated Liner - The insulated
liner should be allowed to drip-dry only. DO NOT use a machine dryer,
direct sunlight, hair dryers or any type of heater during the drying
process.
Pant - DO NOT use a machine dryer. Subjecting the pant to a
machine dryer will damage the pant and possibly the dryer itself. The
only recommended method for drying the pant is drip-drying. Do not
subject the pant to direct sunlight, hair dryers or any type of heater
during the drying process. DO NOT use an iron on any part of the
garment.